Alphacool Silicon Bending Insert 100cm for ID 3/8" / 10mm hard tubes - blue

Alphacool
Alphacool
8,90 €
8,01 €
Up to 10% OFF with
COOL10 code*
In stock
In stock
Ready to ship today
-+
Add to cart
Item code : 13146
EAN : 4250197291170
Non-contractual photos
* Offer valid until 17/12 midnight while stocks last and cannot be combined with any other promotion in progress.
Technical details

For perfect bends in the Alphacool HardTubes now there is the perfect solution.

Simply insert the silicone inside the HardTube and heat the desired location. Thanks to the extremely heat-resistant silicone the pipe can be bent without the curved point kinking. After cooling, the silicone can be easily removed.

Available for HardTubes with 10mm and 12mm inner diameter in each 30cm length for curves in short pipes and 100cm length for curves in longer pipes.

Technical Data

  • Length: 100cm
  • Thickness: 9.2mm
  • Color: blue

Scope of delivery

  • 1x Alphacool Silicon Insert 100cm

 

Notice
Due to the manufacturing process, the diameter can vary by 0.5 - 1mm.

Up to 10% discount on Watercooling by entering the code COOL10 in your basket
Offer valid until 17/12 midnight while stocks last and cannot be combined with any other promotion in progress.

Special offer

30% OFF

Monsoon
MONSOON Rubber Drill Bit for Rigid Tube 10mm Internal - 40cm

2,90 €
2,03 €
30% OFF

The tube should be heated to form certain curves, slide the rubber wick into the tube just before heating it and remove it again when the tube is cool.
This makes it easier to bend the tube and prevent it from warping.

Technical characteristics :

- Diameter: 9.5mm
- Length: 40 cm