 | 
|
EK-FC1080 GTX Ti is a high-performance full-cover water block for NVIDIA GeForce GTX 1080 Ti graphics card, based on Pascal architecture (GP102). Please check our Cooling Configurator online compatibility system for detailed compatibility list!
This water block directly cools the GPU, RAM, and VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC1080 GTX Ti water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. This kind of efficient cooling will allow your high-end graphics card to reach higher boost clocks, thus providing more performance during gaming or other GPU intense tasks. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps.
The base of the block is made of nickel-plated electrolytic copper while the top is made of quality acrylic material. The top also features two pre-drilled slots for 3mm diodes. The sealing is ensured by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.
EKWB recommends the purchase of aesthetic retention backplate (EK-FC1080 GTX Ti Backplate - Black, Nickel) which improves the looks of your graphics cards and also provide some passive cooling to the circuit board VRM section.
G1/4" threaded fittings can be used on both sides of the FC terminal. Up to four EK-FC1080 GTX Ti water blocks can be used on a single ATX form factor motherboard by using EK-FC Terminal (DUAL, TRIPLE or QUAD type) system or other means of interconnectivity. Please note that EK-FC Bridge & Link system is not compatible with this water block.
The block also features a special plastic cover over the block Terminal. This add-on is designed to reveal the graphics card model, visible from the side. The terminal cover is removable, it is fitted with 2 screws from the side. EK also encloses a single-slot I/O bracket which replaces the original two-slot in order to make installation of multiple graphics cards easier and also transforms the GPU into a gorgeous single slot solution.
Enclosed:
- EK-FC1080 GTX Ti series water block
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- 2x EK plug G1/4”
- 6mm Allen key
- Thermal pads
- Thermal grease EK-TIM Ectotherm (1g)
The HEATKILLER® V eBC backplate is a useful addition for the HEATKILLER® V VGA water blocks. Mounted on the backside of the graphics card, it improves the cooling performance while also granting mechanical stability. This is due to the construction out of massive black anodized aluminum. Even more, it also just looks good.
The backplate cools relevant components on the PCB’s backside, including GPU, RAM, and voltage regulation (VRM). Pre-cut thermal pads are included in the scope of delivery.
Isolating spacers on the backside of the backplate ensure easy installation.
The enclosed mounting material is optimized for usage with HEATKILLER® V water blocks. The backplate can be used with water blocks of other manufacturers. You might need to modify the mounting material, though. This is not part of the delivery scope.
Technical data:
Material: Anodized aluminum
Dimensions (L x W x H):
Weight: 150g
Compatible with:
EVGA Geforce RTX 3080/3090 XC3
Please consult the compatibility chart at http://gpu.watercool.de
Scope of delivery:
1x HEATKILLER® V eBC - Backplate for RTX 3080/3090 EVGA XC3 - Black
1x Mounting material
Facebook
Instagram
RSS News
