Alphacool Eisbecher D5 250mm Acetal reservoir incl. 1x Alphacool Eispumpe VPP755 V.3

The Eisbecher D5

This Eisbecher is the big brother of the D5 version. The pump can be attached using a mounting ring and eight screws to hold it. The plexiglass version can be illuminated with four LEDs, which are placed into the pump socket. The lighting module illuminates from above. Small riser pipes and Bubble Down also do their work faultlessly here. The Eisbecher can be mounted either with the mounting bracket or with the included stands. If there is room in the 3.5" hard drive cage inside the case, the pump socket also has threads for this (requires pump decoupling with M4 inner and outer threads - Art. no. 52007).

Scope of Delivery

• 8x M4x12mm screws
• 8x M4x8mm screws
• 4x M4 nuts
• 1x mounting ring
• 1x O-ring ID ca. 54mm
• 2x stands 
• 1x 2.5mm hex key

Dimensions for 150mm version

• Dimensions incl. bracket without stands (LxWxH): 176 x 136 x 80mm
• Dimensions without bracket incl. stands (LxWxH): 223.5 x 87.5 x 80mm
• Plexiglass tube diameter: 60mm
• Capacity: 180ml

Assembly instructions

The Eispumpe VPP755 V.3

The Alphacool Eispumpe VPP755 V.3 improves on the classic D5 VPP655 pump in every way. There is no area where it is weaker or louder than its predecessor, and it instead offers new ways to control the pump to your liking.

Technical Specifications

• PWM controlled pump
• Connection: 4Pin PWM / 4Pin Molex
• Start Boost Function
• Self-venting
• Improved Software
• New bearing for the ceramic axis
• 5 adjustable steps
• • 1. 2100 rpm 120l/h
  • 2. 2700 rpm 140l/h
  • 3. 3330 rpm 280l/h
  • 4. 3950 rpm 320l/h
  • 5. 4350 rpm 340l/h
• Maximum Head Pressure: 4.25m

Scope of Delivery

• Alphacool Eisbecher D5 150mm Acetal incl. 1x Alphacool Eispump VPP755 V.3

Download 3D-file (.stp)

Notice
In order to use the inlet from above, a G1/4" extension piece is required (art. no. 1011183-1011186), as the thread is embedded a few mm into the cap and many screw threads will not be able to reach it.
CAUTION
Removing the impeller from the ceramic shaft will cause the upper ceramic clamping ring to over-expand, which will destroy it! Removal will void the pump’s warranty!

If the pump is put together again and put back into operation, the clamping ring will loosen, which is not accepted as grounds for a return or exchange...