EK Water Blocks EK-FC Titan V - Nickel

EK Water Blocks, EKWB
EK Water Blocks
This product is no longer available for sale
Item code : 14045
EAN : 3830046995742
Non-contractual photos
Technical details

EK-FC Titan V is a high-performance full-cover water block for the most powerful PC GPU - NVIDIA Titan V, Volta architecture-based graphics card.

This water block directly cools the GPU, HBM2 memory, and VRM (voltage regulation module) as well! Water is channeled directly over these critical areas, thus allowing the graphics card and it’s VRM to remain stable under high overclocks and to reach full boost clocks. EK-FC Titan V water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps. 

EK-FC Titan V

The base of the block is CNC machined out of nickel-plated electrolytic copper while the top is CNC machined out of high-quality acrylic material. The sealing is ensured by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.

EK® also encloses a single-slot I/O bracket which replaces the original two-slot in order to make installation of multiple graphics cards easier and also transforms the GPU into a gorgeous single slot solution.

EK-FC Titan V Single slot

EK® recommends the purchase of a retention backplate which improves the aesthetics of your graphics cards, but also provides additional passive cooling to the GPU core and circuit board VRM section. The EK-FC Titan V water block is backward compatible with all EK-FC Titan V Backplates.

G1/4" threaded fittings can be used on both sides of the FC terminal and for multiple GPU connectivity, please refer to our offer of GPU Terminals.

Enclosed:

- EK-FC Titan V water block
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- Single slot PCIe bracket
- 2x EK plug G1/4”
- 6mm Allen key
- Thermal pads
- Thermal grease EK-TIM Ectotherm (1g)

Made in Slovenia - Europe!


Up to 10% discount on Watercooling by entering the code COOL10 in your basket
Offer valid until 17/12 midnight while stocks last and cannot be combined with any other promotion in progress.

Special offer

30% OFF

EK-Vector Radeon VII Backplate is a CNC machined retention backplate made from nickel-plated aluminum for EK-Vector Radeon VII series water blocks.

Backplate covers the whole length of graphics cards PCB, serves as an aesthetic add-on and also provides passive cooling for the backside of voltage regulation module (VRM).

This backplate is guaranteed to be compatible with reference PCB AMD® Radeon® VII graphics cards.

Enclosed:
- EK-Vector Radeon VII Backplate - Nickel
- Mounting mechanism
- Thermal pads

Made in Slovenia - Europe!