EK-FC Titan V is a high-performance full-cover water block for the most powerful PC GPU - NVIDIA Titan V, Volta architecture-based graphics card.
This water block directly cools the GPU, HBM2 memory, and VRM (voltage regulation module) as well! Water is channeled directly over these critical areas, thus allowing the graphics card and it’s VRM to remain stable under high overclocks and to reach full boost clocks. EK-FC Titan V water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps.

The base of the block is CNC machined out of nickel-plated electrolytic copper while the top is CNC machined out of high-quality acrylic material. The sealing is ensured by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.
EK® also encloses a single-slot I/O bracket which replaces the original two-slot in order to make installation of multiple graphics cards easier and also transforms the GPU into a gorgeous single slot solution.

EK® recommends the purchase of a retention backplate which improves the aesthetics of your graphics cards, but also provides additional passive cooling to the GPU core and circuit board VRM section. The EK-FC Titan V water block is backward compatible with all EK-FC Titan V Backplates.
G1/4" threaded fittings can be used on both sides of the FC terminal and for multiple GPU connectivity, please refer to our offer of GPU Terminals.
Enclosed:
- EK-FC Titan V water block
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- Single slot PCIe bracket
- 2x EK plug G1/4”
- 6mm Allen key
- Thermal pads
- Thermal grease EK-TIM Ectotherm (1g)
Made in Slovenia - Europe!
EK-FB KIT ASUS R5E-E10 is a complete liquid cooling solution for ASUS ROG Rampage V Edition 10 motherboard consisting of two separate water blocks. The water blocks directly cool Intel X99 Express southbridge (PCH) chip and power regulation (VRM / MOSFETs) module. Please note this water block cools exactly as much heat generating components as ASUS factory cooling solution. Both blocks utilize a very high flow design, allowing you to use it in loops with weaker water pumps.

The base of both water blocks is made of nickel plated electrolytic copper while the top is made of quality POM Acetal material. The sealing is performed by quality rubber gaskets. Nickel plated brass screw-in standoffs are already preinstalled and allow for easy installation.
A maximum diameter of barbs/fittings on SB part of the water block kit must be 22.2mm (EK-ACF Fitting 10/16mm are the largest fittings that you can use) in order to allow the installation of the graphics card mounted with EK-FC series backplate in the first PCIe x16 slot!
Enclosed:
- 2 water blocks (MOSFET & SB)
- Mounting mechanism
- Thermal pads
- Thermal grease EK-TIM Ectotherm


![]() |
In stock |
![]() |
2 to 5 days delay |
![]() |
1 to 2 weeks delay |
![]() |
unknow delay |
![]() |
pre-order |
$('#basket').addClass('emptypanier');

