 | 
|
The EK-Loop Torque Screwdriver - 0.6Nm is a precision screwdriver with 5 enclosed bits that will allow you to precisely fasten screws. Assemble and maintain your water-cooling equipment without the risk of over-torquing and damaging your gear. It comes with standard bits like Allen (Hex) and Phillips ones, which will be ideal for most water-cooling products like CPU and GPU water blocks, fan and radiator screws, various pump/reservoir mounts, and much more.
It is set to 0.6Nm torque. Upon reaching this force, an audible click is produced and the screwdriver resets. This way, you can no longer break your parts by using too much force as this tool will not allow you to. The soft-grip handle is made of TPR for comfortable use while building a loop.
Temperature sound designed for any 1/4 "thread.
Install probes in multiple locations in your loop to get accurate temperature readings.
Characteristics :
- Standard 1/4 "thread.
- High quality triple strand / triple weave sheathed cable.
- Uses a 10K Ohm sensor at 25 ° C for compatibility with a wide range of peripherals.
- The body of the plug is made of solid brass.
- The probe is made of high quality stainless steel and is thermally separated from the cap body for more accurate temperature readings.
- Knurled for easy tool-free installation.
- The cable measures 50 cm
- 2-pin connector (motherboard, fan controller, etc.)
- Supplied with 2 high quality 2.4 mm thick silicone O-rings.
Delivered with :
1 1/4 "acrylic probe
1 brass fixing ring
2 joints
Facebook
Instagram
RSS News
