 | 
|
EK-Loop Connect - Temperature Plug Sensor is an NTC (negative temperature coefficient) coolant temperature sensor. It allows users to get a precise coolant temperature measurement and to fine-tune the radiator fan speed for an optimal balance between acoustics and performance.
The coolant temperature data can also be used to set up an emergency shutdown procedure if the temperature gets too high, preventing overheating of the system and possible malfunctions.
The body of the temperature sensor plug is made of CNC machined brass with a high-quality Nickel finish, while the seal is made with a quality EPDM rubber O-ring. The G1/4 thread and low installment height allow for easy installation in any unused port in the custom liquid cooling loop. It can be connected to the EK-Loop Connect control hub or a motherboard temperature sensor connector.
Technical Specifications:
- Finish: Nickel
- The outer diameter: 16.5mm
- Installed height: 8mm
- Thread: G1/4”, 4.5mm male thread length
- O-ring material: EPDM 50
- Temperature probe type: NTC, 10KO at 25°C
- Temperature sensing range: 0°C to 90°C
- Connector: 2-pin
- Cable length: 500mm
ROHS compliant!
Designed and engineered by EK Water Blocks in Slovenia - Europe
Made in China
Temperature sound designed for any 1/4 "thread.
Install probes in multiple locations in your loop to get accurate temperature readings.
Characteristics :
- Standard 1/4 "thread.
- High quality triple strand / triple weave sheathed cable.
- Uses a 10K Ohm sensor at 25 ° C for compatibility with a wide range of peripherals.
- The body of the plug is made of solid brass.
- The probe is made of high quality stainless steel and is thermally separated from the cap body for more accurate temperature readings.
- Knurled for easy tool-free installation.
- The cable measures 50 cm
- 2-pin connector (motherboard, fan controller, etc.)
- Supplied with 2 high quality 2.4 mm thick silicone O-rings.
Delivered with :
1 1/4 "acrylic probe
1 brass fixing ring
2 joints
Facebook
Instagram
RSS News
;){kind=link}